☰
Know your ingredients. Create with confidence.
All recipes

Face / RECIPE LAB

SNAP-8 + SYN-AKE

A two-peptide formula card requiring ingredient-form confirmation.

Formula reference
SNAP-8
FaceSNAP-8 + SYN-AKE30 g source batch

Ingredient photo · see the formula status and amounts below.

Build your reference sheet

30 g source batch
Powder units

Follow the stated batch size and recipe notes. Tick ingredients as you prepare your checklist. Changing units does not change the formula.

ReviewedIngredientAmount
SNAP-8 · as labelled in poster1.5 g
SYN-AKE · as labelled in poster0.9 g
Hyaluronic acid base27.6 g

0 of 6 items reviewedYour preparation checklist.

Recipe shopping list

Pack quantities follow the reference amounts above. Tick items you already have. Confirm the formula before purchasing.

Have itIngredient neededShop packs
SNAP-8 · as labelled in poster
1.5 g		SNAP-8 · 1 g
2 packs · $120.00
SYN-AKE · as labelled in poster
0.9 g		SYN-AKE · 1 g
1 pack · $50.00
Hyaluronic acid base
27.6 g		Source separately / confirm specification

Selected available packs: $170.00 · Shipping calculated with your order.

Only matched products with exact mass amounts are added. Bases, water, unspecified amounts and unavailable items are excluded. Pack cost is not the cost of ingredients used.

Suggested final pH

pH guide coming soon

pH guide coming soon.

Check the finished mixture

Measure after all ingredients, preservative and final water have been incorporated and the HA is fully hydrated. Use a calibrated pH meter suitable for the serum or cream, at room temperature.

If adjustment is needed, use a formula-compatible diluted pH adjuster in small, measured additions; mix and remeasure. Recheck after 24 hours at the same temperature. There is no fixed number of drops that works for every batch.

The target must fit every ingredient and the preservative. Reaching it does not establish safety or shelf life.

pH too high? Make a lowering solution →pH too low? Make a raising solution →

Confirm the target and adjuster compatibility before following the guide.

Before preparing this formula

  • Source: owner-uploaded recipe cards, read 18 October 2026. Data transcribed into the Recipe Lab format.
  • The poster lists 5% SNAP-8 and 3% SYN-AKE and calls them powders. These levels must not be treated as recommendations for pure peptides.
  • Lubrizol specifies a 3–10% use level for its SNAP-8 peptide solution C, whose ingredient list includes water and caprylyl glycol. That specification cannot be applied directly to an unspecified raw powder.
  • Confirm the exact supplier material, active content and permitted use level before calculating or mixing. The source pH target of 5.0–5.5 and warming advice are not verified for the materials being sold.

Manufacturer’s SNAP-8 solution specification ↗

Ask the lab about this formula →

INTERACTIVE REVIEW

Preparation outline

  1. STEP 01

    Confirm the exact material forms and use levels before using the source quantities.

  2. STEP 02

    Source order: weigh HA base, incorporate SNAP-8, then SYN-AKE; mix and transfer to an airless bottle only after the complete formulation has been assessed.

  3. STEP 03

    The source suggests pH 5.0–5.5 and gentle warmth. Verify both against the actual ingredients and preservative first.

Use & storage

Topical cosmetic reference only. Keep away from eyes and broken skin. Not for injection, microneedling or lash application.

Confirm preservation, final pH, stability and shelf life for the complete formula. Refrigeration and patch testing do not replace formula safety assessment.

Cosmetic hygiene guidance ↗