Body Peptide Serum — Formula Reference

Build your reference sheet

60 mL base

Powder units

Follow the stated batch size and recipe notes. Tick ingredients as you prepare your checklist. Changing units does not change the formula.

Reviewed	Ingredient	Amount
	GHK-Cu	0.3 g
	Matrixyl 3000	0.1 g
	Hyaluronic acid serum base or cream base	60 mL
	Propylene glycol · optional in source	2–3 mL

0 of 7 items reviewedYour preparation checklist.

Recipe shopping list

Pack quantities follow the reference amounts above. Tick items you already have. Confirm the formula before purchasing.

Have it	Ingredient needed	Shop packs
	GHK-Cu 0.3 g	GHK-Cu · 1 g 1 pack · $10.00
	Matrixyl 3000 0.1 g	Matrixyl 3000 · 1 g 1 pack · $60.00
	Hyaluronic acid serum base or cream base 60 mL	Source separately / confirm specification
	Propylene glycol · optional in source 2–3 mL	Source separately / confirm specification

Selected available packs: $70.00 · Shipping calculated with your order.

Only matched products with exact mass amounts are added. Bases, water, unspecified amounts and unavailable items are excluded. Pack cost is not the cost of ingredients used.

Suggested final pH

5.5–6.5Provisional target

Suggested development target for this recipe. Measure the finished batch; this target is not a tested shelf-life specification.

These are starting targets for formula development, not measured batch results or validated stability specifications.

Check the finished mixture

Measure after all ingredients, preservative and final water have been incorporated and the HA is fully hydrated. Use a calibrated pH meter suitable for the serum or cream, at room temperature.

If adjustment is needed, use a formula-compatible diluted pH adjuster in small, measured additions; mix and remeasure. Recheck after 24 hours at the same temperature. There is no fixed number of drops that works for every batch.

The target must fit every ingredient and the preservative. Reaching it does not establish safety or shelf life.

pH too high? Make a lowering solution →pH too low? Make a raising solution →

Confirm the target and adjuster compatibility before following the guide.

Before preparing this formula

The poster lists 60 mL of base plus other ingredients; it does not establish a final 60 mL batch.
The alternative poster formula lists GHK-Cu 500 mg, Matrixyl 3000 200 mg and SYN-COLL 100 mg with the same base. This higher-strength variant has not been validated.
The additional cellulite poster repeats GHK-Cu and Matrixyl 3000. Its vial labels and device illustration do not provide a separate complete formulation.

Ask the lab about this formula →

INTERACTIVE REVIEW

Preparation outline

STEP 01
Clean and sanitize suitable tools and containers; allow them to dry.
STEP 02
The source describes preparing the peptides separately before gradually combining them with the base. Confirm the appropriate solvent for the exact supplied ingredients.
STEP 03
Mix to a uniform appearance. The source suggests checking and stirring again after 2–4 hours; appearance alone does not verify stability.

Use & storage

Topical cosmetic reference only. Keep away from eyes and broken skin. Not for injection, microneedling or lash application.

Confirm preservation, final pH, stability and shelf life for the complete formula. Refrigeration and patch testing do not replace formula safety assessment.

Cosmetic hygiene guidance ↗